Skip to main content

With Tailscale, I can access my local network through a Tailscale subnet router or connect directly to a machine running Tailscale itself. Either way, I can open Jeedom from my phone. The address I use determines which path the connection takes — and what happens if an intermediary goes down.

Address usedConnection pathIf the Tailscale router goes down
192.168.1.x, the Raspberry Pi's local IPPhone → Tailscale subnet router VM → Raspberry PiAccess cut off from outside
100.x.x.x, the Raspberry Pi's Tailscale IPPhone → Tailscale on the Raspberry Pi directlyJeedom stays reachable

Accessing the local network through 192.168.1.x addresses​

At home, my router, my Raspberry Pi, and my other devices communicate on the local network. In my setup, their addresses fall in the 192.168.1.x range. When I'm on the home Wi-Fi, I use these addresses to reach them.

From outside, my Proxmox VM acts as a gateway. It advertises to Tailscale that it can reach the 192.168.1.0/24 network. My phone can then use the same local addresses to access Jeedom, my router, or my cameras — even if those devices don't run Tailscale.

Limitation: if the VM goes down, the path through it is cut and Jeedom is no longer reachable from outside, even if the Raspberry Pi is running perfectly.


Accessing Jeedom through its Tailscale address 100.x.x.x​

The Tailscale plugin for Jeedom lets me connect the Raspberry Pi itself to my Tailscale network. The Pi then gets its own 100.x.x.x address. With Tailscale running on my phone, I can open Jeedom at that address directly, without going through the subnet router.

Key advantage: if my VM or the NUC hosting the Tailscale router shuts down, Jeedom remains accessible from outside as long as the Raspberry Pi is running. The connection no longer depends on an intermediary.

Bookmarking Jeedom's Tailscale address lets me use it daily and find it easily if the router fails.


Combining both approaches​

Both methods coexist without issue. In my setup:

  • I access Jeedom via its 100.x.x.x address — direct connection, independent of the router.
  • I access my router, cameras, and other devices via their 192.168.1.x addresses — these devices don't run Tailscale, so the subnet router is still useful for them.

If the VM goes down, I lose remote access to my router and cameras, but Jeedom stays reachable. I can then act through the home automation interface.


Further reading​